Router Table Leveler directions

Installing Levelers

Installing the router insert plate leveler is very easy.

You will need a drill, 3/8" bit, a 6mm hex or allen wrench and a 7/16" open end wrench.

1. First make a pencil mark in each corner of the insert hole where you want the threaded
insert to go. I highly recommend the corners, make sure an leave a little room for the lip of
the insert.

2. Drill a 3/8" hole all the way through the table. Make sure you use a piece of scrap
wood on the back side to eliminate blowout from drilling.

3. Take your 6mm hex drive or allen wrench and insert the threaded insert into the hole
until its flush. You can dimple the MDF just a bit for a flush fit.

4. Take a 1/4" bolt and thread on a nut then a washer. Screw this assembly onto the back
side of the table top (bottom)

5. When the screw comes up through the insert flush stop here and do the other 3 holes.
Insert the router plate and take a 7/16" wrench and screw the bolt up till the insert is flush
with the table. Repeat all four holes. Then tighten the nut to the bottom of the table.
Make sure you washer contacts the table bottom snuggly.